Wow, doesn't time fly!!

I must apologise for the delay since my last posting. I can't believe it has been nearly three months! Anyway, the car has been making some progress although to be honest, not as much as it should have in the time elapsed. I have added quite a number of triangulation tubes to the chassis which took a bit longer than expected but should be well worth the effort. I have also completed the floor welding from the top (stitch welded 1 inch in 6) but have yet to seam weld the bottom. I have also been busy cleaning and linishing the remaining welds from anywhere that flat panels will be mounted later. I intend to leave most other welds just as they are unless they are particularly ugly.

That's it for the chassis. The other main item of progress recently is the procurement of a Rover V8 3.5litre engine from a tired old SD1. My original engine source never came good and I got fed up waiting for the engine to appears so when another source appeared I grabbed it with both hands. The donor is a 1977 SD1 which was on the road up until 4 years ago when it was put into storage iin anticipation of a full rebuild of the ailing bodyshell. However, the body went from bad to worse and the owner couldn't afford the parts required. I'm not surprised to be honest as the body is a basket case in my opinion. The engine has done 91K miles and I believe that to be genuine. The oil looked clean and the coolant was nice and blue. There was no gunge in the filler cap and the car started fairly easily once the carbs were primed with fuel. Unfortunately the exhaust was burst wide open so I couldn't easily ascertain that it was running perfectly but it idled at 700RPM happily with good oil pressure and seemed to be on all 8 cylinders so that's good enough for me. I'll do a compression check and might remove the heads for a look and a top-end rebuild if I feel it is justified. The engine cost me £175 complete with all ancillaries, carbs, electrics, clutch, flywheel. I got a few other bits including clutch slave cyl, master cyl, accelerator cable and pedal assembly and radiator expansion tank for another £25. I'm quite happy at that.

Here are a couple of pictures of the donor and engine prior to removal: